AudioCodes Mediant 2600, Quick Setup Manual

Page: 17 / 50

AudioCodes Mediant 2. Installing the Hardware
BroadCloud Hosted UC 17 AudioCodes Mediant CRP

To connect the device to the BroadCloud service (WAN-DMZ):
1. If the device's IP isn't configured yet, connect as shown in Section 3.
2. If the device's IP has already been configured:
a. Connect one end of a straight-through RJ-45 Cat 5e or Cat 6 cable to the RJ-45
port labeled LAN GE port 1.
b. Connect the other end to the DMZ port assigned by the IT administrator.
Figure 2-15: Connecting the LAN Ports

To connect the device to the enterprise LAN:
1. If the device's IP isn't configured yet, connect as shown in Section 3.
2. If the device's IP has already been configured:
a. Connect one end of a straight-through RJ-45 Cat 5e or Cat 6 cable to the RJ-45
port labeled LAN GE port 3.
b. Connect the other end to your local network LAN layer 2 switch port. This port will
be used to communicate with the IP-Phones and/or ATA Devices.
2.3.5 Powering up
The device receives power from a standard alternating current (AC) electrical outlet. The
connection is made using the supplied AC power cord.
Table 2-11: Power Specifications
Physical Specification Value
Input Voltage Single universal AC power supply 100 to 240V
AC Input Frequency 50 to 60 Hz
AC Input Current
1.5A
Warning:
•
The device must be connected to a socket-outlet providing protective earthing.
•
Use only the AC power cord that is supplied with the device.