Audio Note TT-Three, Owner'S Manual

Page: 25 / 29

Tonearm
Connect the tonearm cables and earth wire to your amplifier /
preamplifier’s ‘Phono’ input, or to the input on your Step Up
Transformer if you are using one. The tonearm earth cable should be
connected to the earth / ground post on your amplifier / preamplifier.
Umbilical The TT-Three deck is connected to the PSU by a specific, supplied
umbilical cable. This cable is equipped with locking connectors and
can only be installed one way.
On the rear of the TT-Three plinth is a circular four pin ‘male’ socket;
connect the ‘female’ end of the umbilical cable to this (it can only be
inserted on way) and tighten the locking ring ‘finger tight’.
On the rear of the TT-Three PSU is a four pin circular ‘female’ socket;
connect the ‘male’ end of the umbilical cable to this (again, it can only
be inserted one way), and tighten the locking ring.
PSU The TT-Three PSU is equipped with an IEC 320 mains inlet socket.
Once the umbilical cable has been installed, use the supplied mains
cable to connect the unit to the local mains supply. The mains fuse is
located in the fuse holder on the rear of the unit, just below the mains
inlet socket.
Special Note – Make sure that all connections are tight and clean. For best results
use good quality audio interconnects and mains cables. For best
results and performance, we recommend our own
Audio Note (UK)
range of power, interconnects and loudspeaker cables. For further
information, please consult your nearest Audio Note (UK) dealer, or
alternatively please feel free to contact us directly.
CONNECTION