Should problems occur, they are, in many cases, due to simple operation
mistakes or the like. On the basis of the following checks, you will be able to
rectify a number of problems yourself without difficulty. If the problem cannot be
remedied after the following checks, please consult your dealer.
No sound while
RF signal is
normal and AF
signal does not
exist.
PROBLEM
No sound and no
RF signal
No sound while
RF and AF
signals normal.
The microphone cartridge
of the transmitter is
defective.
POSSIBLE CAUSES
The power of the
transmitter is off.
Incorrect AA-battery
polarity in the transmitter.
Antenna is not on the
receiver or bad antenna
connection.
Transmitter too far away
from the antenna or RF
signal blocked.
Receiver volume turned to
minimum.
Receiver audio cable is
missing or defective.
Volume control of the
sound system connected
to the AWR6952U receiver
is set to minimum.
Return transmitter to factory or
authorized service station for
service.
SOLUTIONS
Turn on the transmitter.
Correct the AA-battery polarity.
Install the antenna or check the
antenna connection.
Reposition the transmitter to
closer area or remove the RF
signal block.
Adjust the volume control knob
to have an optimal volume
output.
Connect, repair or replace the
audio cables.
Adjust the volume control on the
sound system which is
connected to the AWR6952U
receiver.
The mute function on the
transmitter was turned on.
Turn off the mute function on the
transmitter.
If the mute function was not
turned on, the SQ level on the
receiver might be set too high.
TROUBLESHOOTING
-
20
-
