1. The “Channel” icon is used to select the desired channel.
2. In the main menu, press the “▲” or “▼” button to the “Channel” icon.
3. When the “Channel” icon is displayed, press the “SET” button. After the
“SET” button is pressed, the channel number will start to blink.
4. While the channel number is blinking, press the “▲” button to increase
the channel number or the “▼” button to decrease the channel number.
When the “▲” or “▼” button is pressed continuously, the channel number
will be increased or decreased in a fast manner until the button is
released.
5. When the desired channel number is displayed, press the “SET” button
to save. Once the channel number is saved, the AWR6952U will
automatically exit to the main menu and the LCD display will show the
previously selected “LCD Display” menu function.
6. If the channel number blinks 5 times, without pressing the “SET” button,
the AWR6952U will exit to the main menu without saving the selected
channel number.
7. Once the channel number is selected, the AWR6952U will keep the
selected channel number until the channel number is changed later.
SQUELCH (SQ) ADJUSTMENT
1. The “SQ” icon is used to adjust the receiver RF input sensitivity. Higher
receiver sensitivity (lower dB number) incurs a higher RF interference
possibility while lower receiver sensitivity (higher dB number) incurs a
lower RF interference possibility.
2. In the main menu, press the “▲” or “▼” button to the “SQ” icon.
3. When the “SQ” icon is displayed, press the “SET” button. After the “SET”
button is pressed, the “dB” number will start to blink.
4. While the “dB' number is blinking, press the “▲” button to increase the
“dB” number or the “▼” button to decrease the “dB” number. When the
“▲” or “▼” button is pressed continuously, the channel number will be
increased or decreased once only. There are six preset “SQ” levels.
These six preset “SQ” levels are: 0dB, 5dB, 10dB, 15dB, 20dB, and 25dB
(Refer to NOTE). When the maximum “SQ” level (25 dB) is reached,
pressing the “▲” button will not change the “SQ” level further. Similarly,
when the minimum “SQ” level (0 dB) is reached, pressing the “▼” button
will not change the “SQ” level further.
5. When the desired “dB” number is displayed, press the “SET” button to
-
13
-
