Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Front: Position support plates of lifting platform at positions on
underbody shown in illustration -arrows- (near wheel hous‐
ings).
– Rear: Position support plates of lifting platform within indented
circles on underbody -arrows-.
2.2
Engine cover panel: removing and in‐
stalling
10-cyl. petrol engine 5.2 ltr. FSI
2.2.1
10-cyl. petrol engine 5.2 ltr. FSI
Procedure for removing:
– Carefully pull engine cover panel -1- off retaining pins one after
another -arrows-.
Procedure for installing:
– Position engine cover panel on retaining pins and then use
your hands to press it onto retaining pins, one after the other.
2.3
Noise insulation: removing and installing
Noise insulation (front)
Noise insulation (rear)
2.3.1
Noise insulation (front)
Special tools and workshop equipment required
♦ Torque wrench - V.A.G 1783- , measuring range 2 to 10 Nm
♦ Or: torque wrench - V.A.G 1410- , measuring range 4 to 20
Nm
♦ Or: torque wrench - VAS 6854- , measuring range 5 to 13 Nm
♦ Or: torque wrench - VAS 6583- , measuring range 3 to 60 Nm
♦ Or: torque wrench - V.A.G 1331- , measuring range 6 to 50
Nm
Table of tightening torques for installation:
Component/fastener
[Nm]
Securing bolts
10
Audi R8 2015 ➤
Maintenance - Edition 03.2016
4
2. Preparations
