Atrie DB-120 User Manual
User Manual
9
Figure 3 (Setup page)
3.3.1
WIDE AREA NETWORK CONNECTION
On the other side of the router is where your Wide Area Network (WAN) connection; also referred to
as a broadband connection. This WAN connection is different for every WAN supplier. Most of the
configuration you will perform will be in this area. Local Area Network Connection(s)
3.3.2
LOCAL AREA NETWORK CONNECTION
On one side of your router, you have your own Local Area network (LAN) connections. This is where
you plug in your local computers to the router. The router is normally configured to automatically
provide all the PC's on your network with Internet addresses.
3.4
CONFIGURATION THE WAN
Before the gateway will pass any data between the LAN interface(s) and the WAN interface, the
WAN side of the modem must be configured. Depending upon your DSL service provider or your
ISP, you will need some (or all) of the information outlined below before you can properly configure
the WAN:
•
Your DSL line VPI and VCI
•
Your DSL encapsulation type and multiplexing
•
Your DSL training mode (default is MMODE)
For
PPPoA
or
PPPoE
users, you also need these values from your ISP:
•
Your username and password
For
RFC 1483
users, you may need these values from your ISP:
•
Your DSL fixed Internet IP address
•
Your Subnet Mask
•
Your Default Gateway
•
Your primary DNS IP address
