Atrie DB-120 User Manual
User Manual
7
3.
SETTING UP YOUR GATEWAY
This section will guide you through your gateway’s configuration. The gateway is shipped with a
standard default bridge configuration; for most users, you may want to change the gateway from a
bridge to a router.
3.1
LOG INTO YOUR GATEWAY
To configure your gateway, open your web browser. You may get an error message at this point; this
is normal. Don’t panic. Continue following these directions. Type the default IP address
(
192.168.1.1
) Press the
Enter
key and the following screen, shown in Figure 1 will appear. The
default user name is
Admin
(case sensitive) and the password is
password
(case sensitive).
Note: Before setting up your gateway, make sure you have followed the quick start guide. You should
have your computers configured for DHCP mode and have proxies disabled on your browser. Also if
you access the router, and instead of getting a login screen, the browser instead displays a login
redirection screen, you should check your browser's setting, and verify that JavaScript support is
enabled. Also, if you do not get the screen shown in Figure 1, you may need to delete your temporary
Internet files (basically flush the cached web pages).
Figure 1 (Log-in screen)
