Atop Industrial Wireless Access Point
AW5500C
User Manual V. 1.1
70
Steps for a quick setting for the AW5500C as a Regular AP are:
On operation mode choose
“Regular AP”
(if the device is not in factory default).
Go to
Wireless → Basic Settings;
here you can change the
Network Name
(SSID) to
your preferred name, you might want to first click on
“Scan network”
to find whether
there are neighbors with a name matching yours (this is done for preventing any conflict
over networks).
At this point you may decide to change other settings such as the
Wireless Mode
and
whether to have
Automatic Channel Selection.
Next go to
Security Settings,
and on
Security Mode
choose which security protocol will
be used in the network. We strongly recommend not leaving this section as disabled.
On
LAN & WLAN Interfaces,
enter the
IP Address, Subnet Mask, Default Gateway,
and
DNS servers
used (if any), according to your network configuration.
Click
“Apply”,
and wait for the changes to take effect. You may also want to
Save
Settings
afterwards just in case you need these configurations in the future.
Summary of Contents for AW5500C
