Atop AW5500C, User Manual

Page: 44 / 104

Atop Industrial Wireless Access Point
AW5500C
User Manual V. 1.1
39
Scheduler Usage Tutorial:
Let’s say there are two sites that are covered by the AP and they have different working hours.
The office would normally work from 8am to 6pm and the production line should run 24 hours.
Both sites will shut down on weekends Figure 4.18.
Steps

Enable AP2 in the Wireless Basic Setings. Set AP1 to use SSID AW_Production and
AP2 to use SSID AW_Office. Configure other wireless settings when necessary.

Go to Wireless Scheduler Settings and select Rule 1. Give this rule a name (Production
Line), change its status to Enabled, select the SSID (AW_Production), check the days
(Monday ~ Friday), and set 00:00
– 00:00 for
Time. In case you have done something
wrong and would like to discard the changes, press the Cancel button. Click the
Add/Modify button to add this rule or overwrite an existing rule.

Select Rule 2. Give this rule a name (Office), change its status to Enabled, select the
SSID (AW_Office), check the days (Monday ~ Friday), and set the Time range to
8:00-18:00. Click the Add/Modify button to add this rule or overwrite an existing rule.

In case there are other rules present in the table, you can select that rule and press the
Remove button so it would clear.

Click the Apply button to make the new scheduler rules effective.
Note that under this scenario, the wireless function (radio) would be turned off completely on
Saturdays and Sundays.