Atop AW5500C, User Manual

Page: 39 / 104

Atop Industrial Wireless Access Point
AW5500C
User Manual V. 1.1
34
4.4.4 WPS Settings
This option is available only when AW5500C is running in the Regular AP mode. WPS
stands for W i-Fi P rotected S etup, PBC stands for P ush B utton C onfiguration. WPS needs
to be enabled before you can Start WPS PBC . To use this feature, first trigger the WPS
process in AW550 by pressing the WPS PBC button and click on the WPS PBC button on
SW5500C
’s UI or other WPS methods designated by a WPS compatible device, Figure
4.14. After the Start WPS PBC button is pressed, WPS would be triggered and the
AW5500C will wait for 120 seconds for a WPS compatible device to associate with it
automatically.
Figure 4.14
Note that since AW5500C
only supports the “
Configured
” mode of WPS, the following
wireless settings need to set manually before the device would enter the WPS state:
Table 4.6
Operation Mode Regular AP
Basic Settings
SSID User Define
Wireless Mode User Define
Security Settings
Authentication WPA-PSK or WPA2-PSK
Encryption TKIP or AES
Passphrase User Define
*Again, TKIP is not covered in the 802.11n standard and the wireless rate would be limited to
54 Mbps.