Familiarize yourself with the remote control.
2
REMOTE CONTROL
POWER ON/OFF
Press and hold for two seconds
to turn power ON or OFF.
SPEED-CHOICE MODE
Once remote is turned on it automatically
enters speed-choice mode. In this mode
each press of the red button will toggle
between the speed settings (low vs. high).
*Moving the motion controller for the first time
puts you in motor-direction mode (see below).
To re-enter speed-choice mode restart remote.
*MOTOR-DIRECTION MODE
In this mode each press of the red button
change the motor direction (forward vs. reverse).
Remote will remain in this mode
until power is turned off.
WARNING
Never press red button while riding. Bring board
to a complete stand-still before pressing red
button to change motor direction.
SPEED MODE LIGHTS
BATTERY LIGHTS
MOTION CONTROLLER
RED BUTTON (multi-function)
Accelerate
Brake
A solid LED light in this area indicates
which speed mode is active.
A flashing LED light in this area indicates
no connection between board and remote.
Check that board has been turned on. If
so, turn off board AND remote for a few
seconds then turn on again. If this LED is
still flashing follow the steps on the next
page for “pairing remote with board”.
THREE SOLID LIGHTS
BOARD
is full charge
TWO SOLID LIGHTS
BOARD
is mid charge
ONE SOLID LIGHT
BOARD
is low charge
ONE LIGHT FLASHING FAST
BOARD
is very low charge
(Charge immediately!)
Note: if power light on board also starts to flash your
battery is dangerously low. At this point you can no
longer use your remote to accelerate but you
can still use your it to brake. Stop riding.
Charge board fully before riding again.
Push forward to accelerate.
Pull backward to brake.
Note: With one exception (see below*)
the battery lights on the remote refer to
the charge status of the
BOARD
.
*
ONE LIGHT FLASHING SLOW
REMOTE CONTROL
battery is low. Charge via USB.
*Note: All other signals refer to board battery.
