1. After studying the instructions and SAFETY GUIDELINES in this manual put
on your helmet and pads and get ready to ride.
2. Turn your board ON by pressing and holding the power button for 2 seconds
until the power light glows solid red. Wait 5 seconds to give the board’s micro
computer time to boot.
3. Turn remote ON by holding its red button down for 2 seconds. When board
and remote are connected one of the “speed mode” lights on your remote will
be a solid color. Wheels should now spin when motion controller is pushed
forward. If not, you might need to pair your remote and board together the first
time you ride (refer instructions below).
4. For models with LED lighting* each press of the power button (short press,
not press and hold) switches to a new LED color scheme.
5. Beginners should only ride in LOW speed mode (refer previous page). Only
use FAST mode after you feel very comfortable in SLOW mode.
6.Beginners should apply brake before standing on board. Don’t forget your
helmet and pads!
7. When you are ready to go, slide the motion controller forward to start your
adventure. Remember to shift your weight to your front foot before
accelerating.
8. Practice braking while you are still going slow to get the feel for it.
Remember to shift weight to your back foot before braking.
9. Return motion controller to neutral position to coast.
Don’t switch suddenly between speeding up and braking. Smooth is best.
1. Ensure board and remote are both powered OFF.
2. Simultaneously press and hold the power buttons on the board AND the
remote untill you hear 3 beeps (2 short then a long one a few seconds later).
3. Power off both board and remote.
4. Power both back on again (wait 5 seconds for board to boot).
5. One of the “speed mode” lights on your remote should now be solid.
4
3
PAIRING REMOTE WITH BOARD
GETTING STARTED
POWER
BUTTON
POWER
LIGHT
POWER BUTTON /
LED LIGHTING SELECTION BUTTON*
