Operation And Use
46
12AWFSL
SAFETY LEVER (1)
• When turned up, the jack safety is released.
• When turned down, the jack safety can be locked.
LIFTING PEDAL (2)
• When pressed, the hydraulic
fl
uid is started to be delivered from the oil
reservoir of the pump into the jack cylinder: the jack beam begins to rise.
LOWERING PEDAL (3)
• When pressed, the hydraulic
fl
uid is started to be released from the
jack cylinder into the oil reservoir of the pump: the jack beam begins to
descend under the weight loaded.
• The lowering speed can be controlled by change of the foot pressing force
on the pedal.
AIR HOSE FITTING (4)
• It is to be connected with the air hose to the compressed air.
FLUID PORT(5)
• It is to be connected with the hydraulic hose from the pump to the jack
beam cylinder.
8.8.1 To Raise The Jack Beam
Never raise the jack beam over high than the rated height. The
manufacturer will not be responsible for the damage because of
the incorrect operation.
• Check to be sure the hydraulic hose and the air hose are connected
properly;
• Check to be sure the oil in the pump tank is suf
fi
cient;
• Adjust extensions according to vehicle;
• Adjust the lifting adaptor height properly. If necessary, place the
appropriate extensions on the lifting adaptors.
Summary of Contents for 12AWFSL
Page 1: ...Replace This With Cover PDF ...
Page 16: ...Technical Specification 16 12AWFSL Figure 3A Layout For In Ground Installation ...
Page 17: ...Technical Specification 17 12AWFSL Figure 3B Layout For On Ground Installation ...
Page 21: ...Technical Specification 21 12AWFSL Figure 6 Electrical Plan 220V 1Ph ...