Lift Description
11
PVL12
Lift Description
The lift is suitable for lifting motor vehicles having maximum weight as described
in the nameplate on the power side column of the lift. All mechanical parts
such as columns, carriages and lift arms have been built in steel plate to make
the frame stiff and strong while keeping a low weight. The electro hydraulic
operation is described in detail in chapter 8.
This chapter describes the lift’s principal elements, allowing the user to be
familiar with the machine. As shown in fi gure 2, the lift is composed of two
columns: power-side column (1) and off-side column (2) with the extension (3)
on each, each equipped with a carriage (4) and a pair of lifting arms (5) with the
adaptor (6) anchored to the ground by means of the column base. The overhead
beam (7) is equipped with the anti-crush safety bar and an overhead cut-off
switch for protection of the vehicle roof. Raising motion is carried out by pushing
the lifting button on the power unit (8), which delivers the hydraulic fl uid to
cylinders inside the columns. The mechanical safety release is carried out by
pushing the lock release lever (9) on the power-side column. Lowering motion is
controlled by pushing the lowering lever on the power unit and carried out under
the weight of the load lifted. The synchronization is controlled by the equalizer
cables. The arm locks can be engaged automatically when the lift is raised.
Figure 2 – Lift
Summary of Contents for PVL12
Page 1: ...Replace This With Cover PDF...
Page 13: ...Technical Specification 13 PVL12 Figure 3 Layout...
Page 16: ...Technical Specification 16 PVL12 Figure 6 Electrical Diagram 220V 50Hz 60Hz 1Ph...
Page 19: ...Safety 19 PVL12 Figure 7 Safety Signs...
