– 7 –
IP100 / IP108 / IP116
Owner’s Manual
AtlasIED.com
TELEPHONE: (800) 876-3333
1601 JACK MCKAY BLVD.
ENNIS, TEXAS 75119 U.S.A.
Rear Panel
5. Network Connection
This 10/100/1000 Mbits/sec Ethernet LAN port is used to connect the unit to the network using a standard RJ45 connector. This port transmits and
receives control data only. The digital audio from the device is transmitted using the audio network port. Two LEDs are provided to indicate status as
shown in the table below.
6. Audio Network (IP108 / IP116 or IP108-D / IP116-D Only)
These 100 Mbits/sec (CobraNet
®
) or 100/1000 Mbits/sec (Dante
®
) Ethernet LAN ports are used to connect either the CobraNet
®
or Dante
®
digital audio
channels of the device to the network using a standard RJ-45 connector. The Primary and Secondary ports can be used to in applications where there
is a redundant network. Do not connect both ports into the same LAN / VLAN. The BNC connector on the CobraNet
®
version is not used.
Two LEDs on each connector are provided to indicate the status as shown in the table below.
7.
1
/
8
" Mini Phone Connectors (2)
These connectors are used only for local recording and monitoring if connected to suitable microphone and speakers (e.g., self-powered desktop
speakers).
8. Logic Inputs
Eight (8) logic inputs provide a simple method to interface the IP100 to other systems such as fire alarm panels, building management systems,
security systems, etc.. The function of each input is programmed in the system software.
9. Relay Outputs
Eight (8) dry contact relay outputs are provided to send signals from the IP100 to other systems such as fire alarm panels, building management
systems, security systems, etc. Each relay is programmed in the system software. Relays can be programmed to act as zones and trip each time an
announcement or message is active for that zone. Relays can also be used to provide a closure when there is a fault condition present in the system.
10. Auxiliary Audio Inputs
These connectors are used to bring in up to two channels of line level analog audio which may be used for such things as background music (BGM) or
audio to accompany a logic closure.
LED
State
Condition
Link (Left)
Off
LAN link not established
Green (Solid)
LAN link established
Green (Blinking)
LAN activity occurring
Speed (Right)
Off
10 MB/s data rate
Green
100 MB/s data rate
Yellow
1000 MB/s data rate
Condition
Left LED
Right LED
Conductor
Orange (Blinking)
Green (Blinking)
Performer
Orange (Solid)
Green (Blinking)
Fault
Orange (Blinking)
Orange (Blinking)
Secondary Primary
May be Labeled Dante
®
Not Used
