Atlas Copco QAS 60 Pd, Instruction Manual

Page: 49 / 142

- 49 -
4.4.4.2 Qc4002™ MkII menu overview
Main View
The display has 4 different lines. The information on
these lines can change, depending on which view is
used. There are 4 different main views possible:
SETUP / V3 / V2 / V1.
Setup view
V3 view
V2 view
V1 view
The user can scroll through these views with the scroll
buttons:
– The SETUP view shows the module name, the
software version, the date and the time.
– The V3 view shows the application type and the
mode, and some generator measurements. During
synchronisation the V3 view will show a
synchronoscope in the first line.
– The V2 view shows some generator
measurements.
– In the V1 view the user can scroll up and down to
15 configurable screens showing different
measurements of the generator, the bus and the
Mains.
SETUP menu
The control and protection parameters can be
programmed according the application. This can be
done by scrolling through the setup menu to the
appropriate parameter. Each parameter has a specific
channel number and is listed in one of the 4 main
SETUP menus:
– Protection Setup (PROT): Channels from 1000 to
1999 (steps of 10).
– Control Setup (CTRL): Channels from 2000 to
2999 (steps of 10).
– Input/Output Setup (I/O): Channels from 3000 to
5999 (steps of 10).
– System Setup (SYST): Channels from 6000 and
up (steps of 10).