ATIKA KGSZ 305, Operating Manual

Page: 22 / 169

The electrical connection or repairs to electrical parts of
the machine must be carried out by a certified electrician or
one of our customer service points. Local regulations – es-
pecially regarding protective measures – must be ob-
served.
Repairs to other parts of the machine must be carried out
by the manufacturer or one of his customer service points.
Use only original spare. Accidents can arise for the user
through the use of other spare parts . The manufacturer is
not liable for any damage or injury resulting from such ac-
tion.
Description of device
1 Carrying handle with On/Off switch
2 Carrying handle
3 Motor
4 Carbon
brush cover
5 Transport locking pin
6 Set screw for the pulling device
7 Locking lever for the rotary table adjustment
8 Rotary table
9 Table insert
10 Indicator for mitre angle
11 Work piece stop
12 Set screw for work piece stop
13 Laser
14 Battery compartment for laser
15 Protective
cover
16 Pendulum cover
17 Lock for pendulum cover
18 Support
arm
19 Wing screw for support arm
20 Vice
assembly
21 Wing nut for vice assembly
22 Star grip
23 Dust
bag
24 Exhaust neck
25 Incline locking lever
26 Scale for incline angle
27 Indicator for incline angle
28 Set screw for 90° saw head incline
29 Locking nut for set screw (90°)
30 Set screw for 45° saw head position
31 Locking nut for set screw (45°)
32 Set screw for the saw blade position
33 Locking nut for set screw (saw blade position)
34 Set screw for the cutting depth
35 Locking nut for set screw (cutting depth)
36 Stop plate
37 Hexagonal screw for saw blade mounting
38 Front saw blade flange
39 Saw blade (Ø 305 x 25,4 x 80T)
40 Reducing
washer
41 Rear saw blade flange
42 Saw blade locking device
43 Montage-holes
44 Carbon
brush
45 Spanner
Preparing for commissioning
Inserting the batteries
H
ƒ Open the battery compartment (14)
ƒ Insert two batteries of the type Micro LR03 (AAA, not in-
cluded) and observe the specified polarity.
ƒ Close the battery compartment again (14).
Loosen the transport locking pin before first use and after each
transport:
ƒ
Slightly push the handle down
ƒ
Pull out the transport locking pin (5)
L To achieve flawless functioning of the machine, please
follow the instructions listed:
ƒ Place the machine at a location that meets the following
conditions:
−
secured against slipping
−
free of vibrations
−
even
−
free of tripping hazards
−
adequate light
ƒ To ensure a safe position of the saw it must be bolted down
on a solid surface (e.g. workbench or support frame) at opti-
mal working height:
−
Disengage the transport locking pin
−
Make 4 holes in the support matching the holes in the
base plate (43).
−
Bolt the device down.
ƒ
Before each use , check
−
Connection cables for defects (cracks, cuts, etc.)
Do not use any defective cables.
−
the saw blade for flawless condition
ƒ
Do not use deformed or damaged saw blades.
ƒ
Immediately replace a worn or damaged table insert.
ƒ
Connect the mitre crosscut saw to a dust collection device
when cutting wood.
21