ATI
Q46C2 2Electode Conductivity System
Part 4
– Electrical Installation
21
O&M Manual
Rev-H (6/19)
4.7
Junction Box Connection
For installations where the sensor is to be located more than 30 feet from the monitor (max. 60
feet), a junction box must be used. The junction box is shown in Figure 14, and is supplied with a
(2) Pg 9 cord grips for sensor and interconnect wiring.
Note: If sensor is experiencing Low-Slope or Low-Output conditions, due to poor Earth
Ground Connections, move the Shield connection from P/S board to alternate
location on lid, where indicated with an “S”.
Figure 14 - Junction Box Interconnect Wiring
