ATEQ CDP60, User Manual

Page: 21 / 48

Chapter 3 – Start up, adjust and measures
UM-24100D-U User manual ATEQ CDP60 Page 11/36
Chapter 3
START UP ADJUST AND MEASURES
1. STARTING THE ATEQ CDP60
Before using the CDP60 device, be sure that the battery is correctly charged.
Check the pneumatics and electrics connections before the start up of the CDP60 .
Switches on the instrument.
When this is on, the battery level becoming too low
for reliable operation, the " LOW BAT " light will light
on.
For a full scale superior than 5 bars, the instrument
asks to disconnect all pressure source from the
instrument for making the auto-zero. When it's
disconnect, press the ENTER key.
Switch off pressure
Enter If Ok
The instrument starts the auto-zero cycle.
AUTO ZERO
At the end of the auto-zero cycle, the instrument
indicates the current pressure measured and is
ready for measurement.
500.0 Pa
000.0
Note : it's important to make an auto-zero cycle before each measure statement.
2. MEASURES DISPLAY
The instrument displays continuously the current pressure. There's no measurement
start cycle.
500.0 Pa
000.0
Note : the data sending on the RS232 frame are the pressure measurements.