ATEN KE6900R, User Manual

Page: 63 / 324

Chapter 1. Introduction
45
KE9950T / KE9952T (Transmitter) Rear View
No. Component Description
1 Grounding Terminal The wire used to ground the unit connects here.
2 Reset This switch must be pushed with a thin object, such as
the end of a paper clip.

Press and release to reboot the device.

Power off, hold reset then power on the device
while pressing reset to recover from a firmware
upgrade failure.

Press and hold it in for more then three seconds
resets the unit back to its factory default
settings.
3 Audio Ports These mini stereo ports are for the local speakers
(green) and microphone (pink).
4 Power Jack The cable from the DC Power adapter connects here.
5 Function Switch Use this slide switch to set the unit’s mode to:

Auto : Shared (simultaneous) KVM control of the
computer at the Transmitter and Receiver console.*

RS-232 Config/Access Control : The device is
ready to be configured via serial commands through
the RS-232 port. When connected to a KVM over IP
Access Control Box (2XRT-0015G), users can
enable / disable control privileges of the connected
receivers.

Local : Only the local Transmitter has KVM control
of the computer. The Receiver’s KVM access to the
computer is locked.
Note: In Auto mode, RS-232 and audio functions will
work on the Receiver but not on the Transmitter.
6 RS-232 Port This RS-232 serial port is for connecting to a serial
terminal.