ATEN KE6900R, User Manual

Page: 32 / 324

KVM over IP Matrix System User Manual
14
KE6900R (Receiver) Rear View
No. Component Description
1 Grounding
Terminal The wire used to ground the unit connects here.
2 Reset This switch must be pushed with a thin object, such as the
end of a paper clip.

Press and release to reboot the device.

Power off, hold reset then power on the device while
pressing reset to recover from a firmware upgrade
failure.

Press and hold it in for more then three seconds
resets the unit back to its factory default settings.
3 Audio Ports These mini stereo ports are for the local speakers (green)
and microphone (pink).
4 USB Port Use this port for virtual media or a USB peripheral device.
Note: 1. When using a USB disk plugged into this port, see
USB Mode
, page 177.
2. This USB port does not support isochronous
endpoints, therefore USB peripherals that stream
audio or video data, such as speakers or
webcams, will not work.
5 Power Jack The cable from the DC Power adapter connects here.
6 Function Switch Use this slide switch to set the unit’s mode:

Extension : Sets the device to use the normal TX to RX
extension mode.

RS-232 Config : The device is ready to be configured via
serial commands through the RS-232 port.
7 RS-232 Port This RS-232 serial port is for connecting to a serial terminal.
2
5 6
7
3
4
8
9
10
1