ATEN KE6900R, User Manual

Page: 38 / 324

KVM over IP Matrix System User Manual
20
KE6910R / KE6912R (Receiver) Rear View
No. Component Description
1 Grounding Terminal The wire used to ground the unit connects here.
2 Reset This switch must be pushed with a thin object, such as
the end of a paper clip.

Press and release to reboot the device.

Power off, hold reset then power on the device
while pressing reset to recover from a firmware
upgrade failure.

Press and hold it in for more then three seconds
resets the unit back to its factory default
settings.
3 Audio Ports These mini stereo ports are for the local speakers
(green) and microphone (pink).
4 USB Port Use this port for virtual media or a USB peripheral
device.
Note: 1. When using a USB disk plugged into this
port, see
USB Mode
, page 177.
2. This USB port does not support isochronous
endpoints, therefore USB peripherals that
stream audio or video data, such as
speakers or webcams, will not work.
5 Power Jack The cable from the DC Power adapter connects here.
6 Function Switch Use this slide switch to set the unit’s mode:

Extension : Sets the device to use the normal TX to
RX extension mode.

RS-232 Config : The device is ready to be
configured via serial commands through the RS-232
port.
7 RS-232 Port This RS-232 serial port is for connecting to a serial
terminal.
2
5 6 7
3
8 9 10
1
*
11 12
4