Atek HP 8753D, User Manual, Page: 589 / 677

MORE SLIDES NEEDED
Error Number
71
When you use a sliding load (in a user-dened calibration kit), you must set at
least three slide positions to complete the calibration.
NO CALIBRATION CURRENTLY IN PROGRESS
Error Number
69
The
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
RESUME CAL SEQUENCE softkey is not valid unless a calibration is already
in progress . Start a new calibration.
NO DISK MEDIUM IN DRIVE
Error Number
41
Y ou have no disk in the current disk unit. Insert a disk, or check the disk unit
number stored in the analyzer .
NO FAIL FOUND
Service Error
Number 114
The self-diagnose function of the instrument operates on an internal test
failure . At this time , no failure has been detected.
NO FILE(S) FOUND ON DISK
Error Number
45
No les of the type created by an analyzer store operation were found on the
disk or the disk drive is empty . If you requested a specic le title , that le
was not found on the disk.
NO IF FOUND: CHECK R INPUT LEVEL
Error Number
5
The rst IF signal was not detected during pretune . Check the front panel R
channel jumper . If there is no visible problem with the jumper , refer to the
HP 8753D Network Analyzer Service Guide for troubleshooting.
NO LIMIT LINES DISPLAYED
Error Number
144
Y ou can turn limit lines on but they cannot be displayed on polar or Smith
chart display formats .
10-14 Error Messages