Atek HP 8753D, User Manual, Page: 577 / 677

Error Messages in Alphabetical Order
ABORTING COPY OUTPUT
Information
Message
This message is displayed briey if you have pressed 4
LOCAL
5 to abort a copy
operation. If the message is not subsequently replaced by error message
number 25, PRINT ABORTED , the copy device may be hung. Press 4
LOCAL
5 once
more to exit the abort process and verify the status of the copy device . At this
point, the copy device will probably have an error condition which must be
xed. (F or example: out of paper or paper jam.)
ADDITIONAL STANDARDS NEEDED
Error Number
68
Error correction for the selected calibration class cannot be computed until you
have measured all the necessary standards .
ADDRESSED TO TALK WITH NOTHING TO SAY
Error Number
31
Y ou have sent a read command to the analyzer (such as ENTER 716) without
rst requesting data with an appropriate output command (such as OUTPD A T A).
The analyzer has no data in the output queue to satisfy the request.
AIR FLOW RESTRICTED: CHECK FAN FILTER
Error Number
20
Something is restricting the air ow into the analyzer . Check for any debris and
clean or replace the fan lter .
ALL REGISTERS HAVE BEEN USED
Error Number
200
Y ou have used all of the available registers; you can store no more instrument
states even though you may still have sucient memory . There are 31 registers
available , plus the present instrument state .
ANOTHER SYSTEM CONTROLLER ON HP-IB BUS
Error Number
37
Y ou must remove the active controller from the bus or the controller must
relinquish the bus before the analyzer can assume the system controller mode .
10-2 Error Messages