Atag HIDD8471E, Instructions For Usage And Installation

Page: 47 / 116

Cleaning and care
47
GB
5.2 Extraction
Cleaning the grease lters
Clean the grease lter in the dishwasher or in mild soapy
water at least once a month or in the event of excessive
grease deposits and/or intensive use.
Lift the extraction hood before removing the lter. This
makes it easy to remove the lter for cleaning.
The lter can be rinsed in a dishwasher. Turning the
NOTE
Do not place the glass cover too rmly. Risk of glass
breakage.
Glass cover
lters in the dishwasher upside down. Please use only
rinse aid that is suitable for RVS use with aluminium in
order to avoid damaging and discolouring the lters.
Never rinse right next to glasses or light-coloured
porcelain.
Do not operate the extractor without grease lters!
After rinsing the lter, dry it and replace it in the extractor.
Please make sure that the recessed handle is visible
after you have replaced the lter. If possible, wipe the
easily accessible inside of the extractor with a cloth
dampened with detergent every time you replace a lter,
while at the same time paying attention to protruding
parts in the inside of the extractor.
Extractor cleaning and care
The extraction housing is best cleaned every time you
clean the lters.
Condensation water may collect under the extraction
housing after water has boiled rapidly with the lid of the
pot removed. This is quite normal. The water should,
however, be removed and the inside of the extraction
housing cleaned.
Failure to clean the grease lter and the housing in
good time can lead to unpleasant odours at rest and at
the beginning of the extraction process. It is therefore
advisable to carry out this cleaning at least once a month.
It is best to clean the housing with a damp, soft cloth and
mild detergent solution.
Service
The recirculating air lter must remain accessible. If
an activated carbon lter is used, clean or replace the
carbon lter mats as indicated with .
Removable Floor
The oor can be removed for cleaning.
Switch o
ff
the hob and fan and remove the glass cover
and the lter.
Hold the bottom rmly with one hand from below and
open the 4 locks with the other hand. After opening,
hold the bottom horizontally and carefully remove it
downwards.
Drain any liquids and thoroughly remove any impurities.
Clean the accessible inside of the housing. Optionally,
the bottom can be cleaned in the dishwasher.
It must be reset in place after cleaning and attached with
the 4 closures.