Atag HIDD8471E, Instructions For Usage And Installation

Page: 45 / 116

Operation
45
GB
4.25.2 Fan time lag
The fan time lag is used after cooker in order to remove
cooking odours. The lter is also dried in the fan.
Setting the fan time lag
1. Select the fan indication.
2. Then use the Plus key or the Minus key of the timer
to set the required time for the fan time lag.
Left position: hours
Centre position: every 10 minutes
Right position: every minute
3. After a few seconds your input will be assumed and the
procedure will have commenced.
The timer symbol of the fan lights up.
4. The fan will be switched o
ff
when the time has lapsed.
If a cooking zone is switched on, the timer does not run
until the cooking zone has been switched o
ff
. If the hob is
switched o
ff
using the On/O
ff
key during fan after run-time,
the timer runs down to a low fan level.
4.25.3 After run time
The fan motor should continue operating for another
10 - 20 minutes every time the hob has been used for
cooking.
If the fan is in operation and no fan run-on is set, there is an
automatic run-on of 5 minutes at level 1 after switching o
ff
.
This guarantees optimal functioning and the removal of
remaining cooking steam.
When using a recirculating air lter, please always allow for
a stop delay time of 10 - 60 minutes in order to optimally
remove cooking odours.
When the fan is switched on again, in rare cases the odour
molecules present in the lter may be combined with steam
so that they are detected again. These remaining odours will
disappear when the fan continues to operate.
NOTE
When the convection air mode is in operation, ventilation
must be su
ffi
cient in order for the air humidity to be
removed.
Replacement of the lter
If an existing carbon lter must be cleaned or replaced, this
is indicated in the fan display by a (after 150 hours of
operation).
When the fan is switched on, the display for a cooking
process is deleted.
To reset the display, the fan display and the sensor eld must
be pressed simultaneously for approx. 3 seconds.
If no carbon lter is used, the display indication must also
be reset.