Chapter 3: Motherboard information
3-12
• Pin 20 on the IDE connector is removed to match the covered hole on
the Ultra ATA cable connector. This prevents incorrect insertion when you
connect the IDE cable.
• Use the 80
–
conductor IDE cable for Ultra ATA 100/66/33 IDE devices.
Drive jumper setting
Mode of
device(s)
Cable connector
Single device
Cable-Select or Master
-
Black
Two devices
Cable-Select
Master
Black
Slave
Gray
Master
Master
Black or gray
Slave
Slave
If any device jumper is set as “Cable-Select,” make sure all other device
jumpers have the same setting.
P5E WS PRO
®
P5E WS Professional IDE connector
NOTE:
Orient the red markings
(usually zigzag) on the IDE
ribbon cable to PIN 1.
PRI_IDE
PIN 1
2. IDE connector (40-1 pin PRI_IDE)
The onboard IDE connector is for the Ultra DMA 133/100 signal cable. There
are three connectors on each Ultra DMA 133/100 signal cable: blue, black,
and gray. Connect the blue connector to the motherboard’s IDE connector,
then select one of the following modes to configure your device.
Summary of Contents for TW300-E5/PI4
Page 12: ...xii ...
Page 68: ...Chapter 3 Motherboard information 3 22 ...
Page 132: ...5 22 Chapter 5 RAID configuration ...