Chapter 2: Hardware setup
2-14
2.6
Hard disk drives (HDD)
The server system supports three (3) 3.5-inch Serial ATA hard disk drives via the hard disk
drive bays and one 2.5-inch HDD/SSD drive at the bottom of the HDD cage.
Installing 3.5-inch HDDs
To install 3.5-inch Serial ATA hard disk drives:
1.
Remove the side cover of the chassis. Refer to the
Removing the side cover
section
for more information.
2.
Prepare the 3.5-inch HDD and the bundled set of screws.
3
.
Locate the HDD cage lock, press the it up (A), then swing the HDD cage outwards (B)
until it clicks in place.
4.
Align and insert the 3.5-inch HDD into
the drive bay ensuring that the screw
holes on the HDD matches the screw
holes on the HDD cage.
screw holes (HDD)
HDD cage lock
HDD cage
screw hole (HDD cage)
Summary of Contents for TS110-E8-PI4
