Asus RS100-E10-PI2, User Manual

Page: 110 / 166

5-24 Chapter 5: BIOS Setup
Device power-up delay [Auto]
Allows you to set the maximum time the device takes before the device reports itself to the
host controller properly.
Configuration options: [Auto] [Manual]
The following item appears only when you set
Device power-up delay
to
[Manual]
.
Device power-up delay in seconds [5]
Allows you to set the device power-up delay in seconds. Use the <+> or <-> to adjust
the value. The values range from 1 to 40.
Mass Storage Devices
Allows you to select the mass storage device emulation type for devices connected.
Configuration options: [Auto] [Floppy] [Forced FDD] [Hard Disk] [CD-ROM]
5.5.12 Network Stack Configuration
Allows you to configure the network stack configuration.
Network Stack [Disabled]
Allows you to enable or disable UEFI Network Stack.
Configuration options: [Disabled] [Enabled]
The following items appear only when you set Network Stack to [Enabled] .
Ipv4 PXE Support [Disabled]
Enables or disables the Ipv4 PXE Boot Support. If disabled, Ipv4 PXE boot option will
not be created.
Configuration options: [Disabled] [Enabled]
Ipv4 HTTP Support [Disabled]
Enables or disables the Ipv4 HTTP Boot Support. If disabled, Ipv4 PXE boot option will
not be created.
Configuration options: [Disabled] [Enabled]
Ipv6 PXE Support [Disabled]
Enables or disables the Ipv6 PXE Boot Support. If disabled, Ipv6 PXE boot option will
not be created.
Configuration options: [Disabled] [Enabled]
Ipv6 HTTP Support [Disabled]
Enables or disables the Ipv6 HTTP Boot Support. If disabled, Ipv6 PXE boot option will
not be created.
Configuration options: [Disabled] [Enabled]