32
GigaX2024/2048 L2 Managed Switch User Manual
4.6.3 Trap Setting
By setting trap destination IP addresses and community names, you can enable
SNMP trap function to send trap packets in different versions(v1 or v2c). Click
OK
to make the setting effective immediately. Click
Reload
to refresh the
settings to current value. To save configuration permanently, please go to
Save
Configuration
page, then click on
Save
.
Figure 40. Trap Setting
4.6.4 VACM Group
VACM(View-based Access Control Model) Group is used to configure the
information of SNMPV3 VACM Group.
Group Name:
enter the security group name. Multiple same names are
allowed. Group name(Security Name) for SNMPv1&v2 is ro_noauth or
rw_noauth only.
Read View Name:
enter the Read View Name that the Group belongs. The
related SNMP messages are Get, GetNext, GetBulk.
Write View Name:
enter the Write View Name that the Group belongs. The
related SNMP message is Set.
Notify View Name:
enter the Notify View Name that the Group belongs. The
related SNMP messages are Trap, Report. Inform request. Note that this
aspect of access control is not currently supported.
Security Model:
enter the Security Model Name that the Group belongs.
Any is suitable for v1,v2,v3. USM is SNMPv3 related.
Security level:
enter the Security level Name that the Group belongs. Only
NoAuth, AuthNopriv, AuthPriv can be chosen. Itʼs all accepted that security
level of PDU is greater or eaual.
Click on the
Add
when you create a new VACM group entry by the above
information. Then you will see the new added entry shows in the group window.
