21
GigaX2024/2048 L2 Managed Switch User Manual
Priority:
the port priority in the switch. Low numeric value indicates a high
priority. The port with lower priority is more likely to be blocked by STP if a
network loop is detected. The valid value is from 0 to -240.
Cost:
the valid value is from 1 to200000000. The higher cost is more likely
to be blocked by STP if a network loop is detected.
Edge Port:
All ports are set to be edge ports by default. Edge port becomes
STP port when BPDU is received. Also, it takes very short time for an edge
port to be in forwarding state.
Point to Point:
Auto/Yes/No. A full duplex link is considered as a point to
point link. Otherwise, it is a shared link. Point to point link may have less
convergence time. Auto is recommended in most cases.
Click on
OK
to make the setting effective immediately. Click on
Reload
to
refresh the setting to current value. To save configuration permanently, please
go to
Save Configuration
page, then click
Save
.
Figure 22. Spanning Tree
4.5.2 Link Aggregation
This page is used to configure the link aggregation group (port trunking). The
switch can have 6 link aggregation groups.
Show Trunk:
Select “Add a new Trunk” for a new created group, or select
an existing group to display related fields and port icons.
Port Selection Criterion:
the algorithm to distribute packets among the ports
