Quick start - starting operation of the U 158
Operating manual U 158 -
Version 10-2018A
page 12
Status line (header) [1]:
displays general information on the module.
SW: Software status
FW: Current version of the software installed
HW: Hardware version
Up: Runtime since the system was booted
Time: Date and time
Name, location, contact: corresponds to the settings which were made in the “User settings”
configuration area
Navigation menu [2]:
displays the individual configuration areas which can be selected by
clicking the mouse. A detailed description of these areas can be found on the following pages of
this chapter.
Content area [3]:
The respective configuration form – depending on the menu item selected – is
displayed here.
HINWEIS
:
The browser display is not updated automatically. Use the corresponding button
in the menu of your browser to update the display.
Logging in
To log in, enter the IP address of the U 158, which appears in the device display, into the address line
of the browser. The menu page “Status” will then appear. Select the item “Log in” from the navigation
menu at the left. The input mask for the log in should then appear (see figure 6, below). In delivery state,
you must use the following log-in data:
User name:
“user” or “admin” (input without inverted commas)
Password:
astro
Figure 5: Log in
After logging in, the start page of the U 158 with all relevant system information will appear. The navi-
gation menu and the log-in status display will appear at the left.
Only one user can be logged into the user interface of the U 158 at a time. The current user is displayed
in the column at the left, below the menu.
The device status is indicated by a green or red circle. If a green circle is displayed, the device is op-
erational. If the circle is red, then a fault has occurred.
A list of current errors is available under the menu item “Active alarms”.
HINWEIS
:
For reasons of security, you should change the access data valid upon delivery
(user name and password) to prevent unauthorised access!
The procedure is described in the section “Changing user data”.
