“TX 1..8 (MPTS)” menu
Oerating manual U 144 -
Version 08-2016A
page 40
“TX 1..8 (MPTS)” menu
To configure the 8 MPTS channels, start by clicking, in the menu at the left, on the item “TX 1..8
(MPTS)”. The following table will then appear in the content area at the top:
Figure 38: Table 1 “IP TX settings (MPTS)”
Here you can select the desired program source for each channel in column „Source“ fom a dropdown
list. Each channel can be routed to one of the outputs A or B respectively to to both channels by clicking
the radiobutton „On“. Type in the IP port into the corresponding input fields.
Click on the „Submit“ button below the last table to store changes.
Click on the „Reset Form“ button to restore the original settings.
To configure one of the 8 MPTS channels click on one of the items TX1“, „TX 2“, „TX 3“ ... „TX 8“ in the
left column. You will then see the following table:
Figure 39: Table 1 „IP TX1 Channel Settings“
You can activate or deactivate forwarding of the selected IP output to ports A and B respectively by
clicking on the corresponding radio button. The MAC address is displayed for ports A and B respec-
tively (“Destination MAC”).
You can enter one value for ports A and B respectively for the following parameters:
Transmit IP: Port:
Enter the transmit IP address here.
Destination IP: Port:
Enter the transmit IP address of a reception device here.
TOS/TTL:
You can enter a value for the “Type of service” here (which is used for prioritising the
IP data packets). Enter a value for the validity period here (“Time to Live”).
VLAN (Set 0 to disable):
Enter the address of a virtual local network here.
Summary of Contents for U 144
Page 1: ...Version 08 2016A ...
