page 29
“Input Settings” menu
Oerating manual U 144 -
Version 08-2016A
You can configure the following parameters for the four respective SAT inputs here:
Satellite:
Select the required satellite (e.g. ASTRA, Eutelsat, etc.) from the drop-down menu
here.
Polarisation/Band:
Select the required polarisation level from the drop-down menu.
Voltage:
Select the required supply voltage.
22 kHz Tone:
Select whether a 22 kHz pulse conversion should be activated. To do so, activate
the corresponding radio button. When you activate “Auto”, the 22 kHz tone is automatically acti-
vated for the high band.
Sensor:
Measured LNB feed voltage/current
LNA Gain:
amplification of low noise amplifier
If you change the activation or deactivation status of inputs or outputs in one of the two tables, then click
on the “Submit” button below the last table to save your changes. Click on “Reset form” to restore the
original settings.
Satellite settings
You can enter settings for selecting the satellite used for reception in the “Input Settings” table.
Figure 28: “Satellite DiSEqC Settings” table
You can enter DiSEqC settings for the individual satellites here. You can select the following parame-
ters individually using the respective drop-down menu:
Port group 0 (Committed):
Select one of the options “A”, “B”, “C” or “D” from the drop-down
menu here.
Port group 1 (Uncommitted):
Select a value between 0 and 15 from the drop-down menu.
Port group 2 (Expansion):
Select a value between 0 and 15 from the drop-down menu.
Port group 3 (Expansion):
Select a value between 0 and 15 from the drop-down menu.
If you change the activation or deactivation status of inputs or outputs in one of the two tables, then click
on the “Submit” button below the last table to save your changes. Click on “Reset form” to restore the
original settings.
Summary of Contents for U 144
Page 1: ...Version 08 2016A ...
