“CAM 1 - CAM 4” menu
Oerating manual U 144 -
Version 08-2016A
page 36
“CAM 1 - CAM 4” menu
This section tells you how to make the decryption settings for the four CAM modules.
The procedure is described in the following.
To have the input screen for the module configuration displayed, click on one of the items “CAM1”,
“CAM2”, “CAM3” or “CAM4” in the menu at the left.
CAM module information
The respective name of the module as well as the current status is displayed in the upper table. If the
module is functioning properly, the message “running” appears. If a CAM module has not been in-
stalled, then the message reads “no CAM installed”. Other error messages are “CAM error temperature
too high” and “voltage error”.
Figure 32: CAM module information
Click on the “+” symbol in the left column to have an overview of the CA systems displayed.
If you click on the “Menu” button in the right column, the MM menu for the module opens.
Entering decryption settings
The second table allows you to add the service for decryption and – if preferred – to limit the decryption
to individual elements.
Figure 33: Selecting services for decryption
To add a service, start by selecting the service in the “Select” column, or enter the SIDs manually in
the input fields. Click on the “+” symbol in the right column. The service will now be added.
You can set different SIDs for the redundant sources of reception.
Details on the redundancy concept can be found in the section “IP RX menu”.
Depending on the active source, either Primary, Secondary or Tertiary is flagged as active.
.
Summary of Contents for U 144
Page 1: ...Version 08 2016A ...
