Astera LED Technology GmbH
Technical Reference Manual for FP1 Titan Tube 2020-08-26
Page | 31
7.21
I
NFO
Set the Radio PIN. To change
the PIN, press ENTER. Adjust
each digit with the + and
–
keys,
cycle through the digits with the
MENU key. When finished, press
ENTER again.
Enable to match color and
brightness of your Titan Tube to
AX1 Pixeltubes so that they can
be used side by side.
Tells the serial number of the
light and the CPU type (43xx).
The firmware version and
hardware version of the light.
The hour-counter is counting up
as long as the light is powered
up. It does not count if the light
is powered off and charging.
While the light is receiving an
UHF signal, this tells the signal
strength and deviation.
Shows the firmware of the built-
in LumenRadio CRMX chip
The current charging state of
the battery in percent.
Shows how many battery cycles
the built-in battery has passed
already
Gives information about the LED
calibration stored in the light, for
service reference only.
7.22
R
ESET
S
ETTINGS
Return the light to the default
settings. This may be done
before each use to start from a
known point. The Radio PIN and
the CRMX pairing stay.
HINT
Main menu:
INFO
Radio PIN:
0000
Serial number:
000-00000 43xx
Firmware version
5.2.20.U HW001
RF link:
-36.0dBm -0.0ppm
Battery state:
100%
Calibration:
2015-04-20-0001
Main menu:
RESET SETTINGS
ARE YOU SURE?
NO YES
CRMX Version:
V1.0.5.0
Battery Cycles:
003
AX1 Compatibility
ENABLED
Power-on hours:
00001h
