Astera LED Technology GmbH
Technical Reference Manual for FP1 Titan Tube 2020-08-26
Page | 13
If an update was found, the LED flashes green/blue until the update has been installed.
4.6.5
To update powerbox software:
1.
Connect to a LAN which has an internet access. Be sure that the powerbox is in Art-
Net DHCP mode: blue LED is on.
2.
Hold the button down -> LED blinks blue -> hold still -> stops blue blinking after 4 sec.
3.
Then the LEDs turn red for a moment. If an update was found, the LED flashes
green/blue until it is done.
4.6.6
To change the universe id manually:
When the powerbox is in the normal mode a long press(4 seconds)
*
enters the universe
id setting mode. In this mode the blue LED blinks shows the universe id. For example; if the
universe id is 8, the blue LED blinks 8 times then it stops for 2 seconds, this sequence is looped.
A single short press increases the universe id. As the maximum id is 16 in this mode, a single
short press sets to 1 if the universe id is 16. During the universe id setting mode a long press(4
seconds) goes back to normal mode.
*
be aware that 8 seconds long press enters the reset mode and restore the universe ID to 1
again.
