18
MP9800 Series
Access 600 Integrated Wiegand
with and without MELR Option (Electric Latch Retraction)
Installation Instructions
Multi-Point Lock
FM437 11/18
Copyright © 2018, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole or
in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
For installation assistance contact Corbin Russwin
1-800-543-3658 • [email protected]
12
Concealed Door Position Switch Installation
A. Use concealed door position switch
708F989 with this product:
1. Concealed door position switch 708F989 is
included with this product. System integrator
shall determine use and installation location.
2. Drill a 1" diameter hole for both magnet and
switch. Both holes shall be 1" deep and for
switch (if needed) drill a 1/4" hole for wires.
3. Connect common wire of switch to common
input terminal of EAC.
4. Connect normally open wire of switch to
normally open input terminal of EAC.
(Figure 26)
Door
Position
Switch
McKinney
Electric
Hinge
Green
(
)
NC
White (C)
Wiegand Access
Control System
12
: Optional 24
VDC
VDC
Lock Available
(Reader is always 12
)
VDC
13
Mechanical Operation Check
1. For devices with auxiliary controls, insert
key into cylinder and rotate. Key will unlock
thumbturn. Turn thumbturn to retract rods
and latches. Key and thumbturn should rotate
freely.
2. For devices without auxiliary controls, unlock
trim in Section 14: Step 5. Confirm that lever
retracts rods and latches.
Figure 26
