17
FM437 11/18
Copyright © 2018, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole or
in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
For installation assistance contact Corbin Russwin
1-800-543-3658 • [email protected]
MP9800 Series
Access 600 Integrated Wiegand
with and without MELR Option (Electric Latch Retraction)
Installation Instructions
Multi-Point Lock
11
Installation continued
Inside of
Door
8-32 x 3/8"
Phillips Flat Head
Undercut Combo
Screw
P4
P3
3. Twist into place, perpendicular with
door. (Figure 22)
4. Position green/yellow ground wire ring
terminal (from lockbody) over hole for
top left screw. (Figure 22)
5. Position green/yellow reader harness
earth ground on top of ground ring
and thread both with one (1) 8-32 x
3/8" Phillips flat head undercut combo
screw. (Figure 23)
IMPORTANT: Note orientation of
ground ring terminals.
6. Tighten securely.
Connector Attachment
(Exterior PCB Assembly)
1. Connect P3 (2-pin connector) from
lockbody to J3 on module. (Figure 24)
2. Connect P4 (6-pin connector) from
lockbody to J4 on module. (Figure 24)
N. Position inside escutcheon and wires.
(MELR) M802 or M812
1. Position escutcheon against door by
hooking top edge on top of MELR
assembly. Verify that no wires are
being pinched.
2. Mount inside escutcheon assembly
to plate using one (1) #8-32 x 5/8"
Phillips flat head undercut machine
screw. (Figure 25)
Figure 22
Figure 23
Figure 24
Figure 25
M802 MELR
M812 MELR
