16
MP9800 Series
Access 600 Integrated Wiegand
with and without MELR Option (Electric Latch Retraction)
Installation Instructions
Multi-Point Lock
FM437 11/18
Copyright © 2018, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole or
in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
For installation assistance contact Corbin Russwin
1-800-543-3658 • [email protected]
11
Installation continued
L. Connect ElectroLynx harness.
(For Access 600 x M812)
1. Connect P5 (7 Pin Connector) from reader
board to J5 on interior escutcheon PCB
assembly. (Figure 20)
2. Connect ElectroLynx harness (4 and 8-pin)
from door to interior PCB assembly.
(Figure 20)
NOTES:
• Neatly fold wires into remaining space to
prevent pinching wires when mounting
escutcheon.
• Do not tuck extra mortise lockbody wires
back inside lockbody cylinder hole.
• Connectors attach properly in only one
orientation.
• Do not offset connector.
• Be sure connection is secure by gently
tugging on wire.
J1
J2
P5
8-pin
ElectroLynx
4-pin
ElectroLynx
PCB Layout - Wire Assignments - ElectroLynx Assembly (Molex)
J2
J1
1-Violet Lock Neg
Actuator (+)
Solenoid (-)
3-Pink
-
1- Black
PWR NEG
3-White
DATA 1
5-Orange
RX (NO)
7-Brown
EGND
2-Gray Lock Pos
Actuator (+)
Solenoid (-)
4-Tan
-
2-Red
PWR POS
4-Green
DATA 0
6-Blue
RX (COM)
8-Yellow
LED
Figure 20
M. Install controller.
(For Access 600 x M812)
1. Once wires are arranged, position
controller at a rotated angle against
door, under earth ground wire.
2. Press piece against door while turning
clockwise. (Figure 21)
Rotate Clockwise
Figure 21
