7
FM336 9800 TCWI1 Series
Copyright © 2018 Corbin Russwin, Inc., an ASSA ABLOY Group company.
All rights reserved. Reproduction in whole or in part without the express
written permission of Corbin Russwin, Inc. is prohibited.
4) Installation Instructions
Sleeve
for Metal
Door
DPS
Harness
Ground
Connect RX connectors
(2)1/4 - 20
Oval head
screws
(2) Finish
washers
Motor Harness
DPS
Motor Harness
Trim assembly
Cover
Gasket
(optional)
Gasket Application:
Peel off the adhesive protective from
gasket. Feed trim assembly motor
harness through gasket opening as
shown and firmly press gasket to
escutcheon, aligning edge of gasket with
the edge of the escutcheon.
Outside Trim Assembly
1. Route motor harness pigtail thru 3/4" diameter hole "C" on inside of door and out other side through
trim assembly prep. Connect to trim assembly motor harness.
2. Route RX connector thru hole "C" on inside of door, thru race way between hole "C" and trim cutout,
and through 1/2" diameter hole "D" back to inside of door.
Connect to the RX connector from the device.
3. Mount trim assembly to door pulling slack wire from motor harness pigtail towards device side of door.
Be careful not to pinch harness wires.
4. When mounting trim, lift tailpiece to pass through hole on device side. Ensure tailpiece is in
vertical position.
5. Fasten trim assembly to door through holes "A" using (2) 1/4-20 oval head screws and two (2)
finish washers.
Finger tighten only!
4
