13
P/N LT-503200 Rev B
21. Insert four (4) AA alkaline batteries; the lock
will flash, beep several times and respond with
voice prompt:
"
Welcome to the Arrow Revolution
".
22. Install battery cover and tighten Phillips
head screw.
IMPORTANT:
Before installing the batteries,
test the lock's mechanical operation.
Place the thumbturn in the
horizontal
position. Lift up and push down on interior lever
handle to retract the latch;
Next place thumbturn in the
vertical
position. Lifting or pushing down on either lever
handle should
not
retract the latch.
Finally, insert key in cylinder and rotate clockwise until thumbturn moves to vertical
(unlocked) position.
If operation is not smooth for any of these procedures, review the previous steps to
ensure proper installation, while maintaining proper alignment of escutcheons.
Install Batteries
Figure 22
CW
Figure 24
Figure 23
CCW
Install the Interior Lever
NOTE
: Hex set screw should be inserted
enough for lever handle to slide over
shank, clearing set screw.
18. Install hex set screw.
A. Place set screw in hole on side of
shank toward latch (Fig. 22); turn set
screw CW to allow for placement of lever
handle over shank.
Do not overtighten.
A. Remove hex key.
19. Place interior lever handle over shank
until hole on handle aligns with set screw
in shank.
20. Secure lever handle by inserting hex key and
rotating set screw
CCW
(Fig. 23).
This will retract the set screw back into the
lever handle to secure it in place.
Do not overtighten.
NOTE
: Thumbturn should still be in horizontal position.
