11
P/N LT-503200 Rev B
Hex Set
Screw
RH/RHR
LH/LHR
NOTE: For correct lever handing, the
hex set screw for the exterior
lever shank must be installed
as shown (Fig. 16).
Figure 16
A.
Once correct handing is determined
, remove the
clip that has held the hub in its correct position by
spreading clip ends to extract clip from shank as
shown in Fig. 15.
Do not rotate cam from its original position.
("Top" is marked RED)
11. Remove clip from shank.
12. Install hex set screw.
Install the Exterior Lever
A. Place set screw in hole on side of
shank toward latch (Fig. 16); turn set
screw Clockwise to allow for placement of
lever handle over shank.
Do not overtighten.
CW
Figure 15
13. Install cylinder in exterior lever.
A. Install cylinder in exterior lever handle as
shown in Fig. 17.
B. Insert key in cylinder.
Figure 17
Tailpiece
90°
Figure 18
(If necessary, remove key from cylinder)
B. Remove hex key.
While supporting cylinder tailpiece (with finger)
rotate key 90°
clockwise (CW) to vertical position
regardless of lever handing.
See
Figure 18.
