5
80-0180-339, Rev 2
Set the Operation Mode
NOTE 1:
The PS-SE has two operation modes, Single Input (Sequential
Operation) and Dual Input (Independent Operation), as
follows:
Single Input (Sequential Operation)
Application:
Control one opening
Operation:
Either input retracts Exit Device #1,
immediately followed by Exit
Device #2.
Dual Input (Independent Operation)
Application:
Controls two separate openings
Operation:
Input IN1 retracts Exit Device #1,
Input IN2 retracts Exit Device #2.
NOTE 2:
The PS-SE is factory preset for Single Input (Sequential
Operation).
1. SET the desired operation mode using SW1 dip switch 1 on the
PS-SE.
Figure 2. Operation Mode
Set the Hold Open Time
NOTE:
The PS-SE has two hold open timers.
1. PERFORM the following to set the hold open times.
a. SET the hold open time for Exit Device #1 using SW1 dip
switches 3, 4, and 5 (see Table 1,
“Solenoid Hold Time Settings
for Exit Device #1,” for settings and hold times, and Figure 3,
“SW1 Dip Switch Settings,” for hold time settings example).
