ASR Audio Systems Friedrich Schaefer, D-35745 Herborn, Germany +49 / 2772 – 42 905
High End Integrated Amplifier ASR Emitter I and II version 2009 on Page 9
Tipp:
connect your CD player to the ASR Emitter and play a CD with dynamic music or a
dedicated burn-in-CD in repeat mode a few times (ASR Emitter volume level 20 and 30).
If you are not playing the ASR Emitter for more than a week, the same effect may occur,
but not as apparent as when connected for the first time. After one or two days of listening
the ASR Emitter sounds as good as the unit did before.
Tipp:
if you are absent for more than three days, please disconnect all the power cords from the
AC outlet. This is the safest and cheapest way to prevent your Audio system from any damages.
To keep the Batteries in good condition please charge the battery unit at least one day a month !
Like any other high-end amplifier, the ASR Emitter sounds best about one hour after you put the
left control knob to the „1“ (ON) position.
Tipp:
about 1 hour before you want to listen to music, turn the ASR Emitter on.
Just turn the ASR Emitter Off, if you are not listening to music for more than three hours.
3.0
Operating the ASR Emitter
3.1
General operation of the ASR Emitter
All functions of the ASR Emitter can be controlled by the three golden or chromium knobs
on the front panel of the main unit. The operation via remote control is even more convenient.
The status of the ASR Emitter is shown in the display on the front panel.
The external power supplies of the ASR Emitter are operating at low levels in energy saving
mode: the output and driver voltages of the ASR Emitter are cut in half in this mode.
For a longer life of the built in parts, after switching ON the ASR Emitter is operating in the
energy saving mode for one minute.
After connecting the ASR Emitter, please set the left knob to the „Standby“-position. Now you
can either set the left knob to the „1“ (On)-position or use the remote control to turn the unit ON.
3.2
Front panel control knobs of the ASR Emitter