ASR Audio Systems Friedrich Schaefer, D-35745 Herborn, Germany +49 / 2772 – 42 905
High End Integrated Amplifier ASR Emitter I and II version 2009 on Page 3
2.
The Emitters are equipped with AC power cords which three plugs that include an
earth
ground connection
. To prevent shock hazard, the earth ground connection should be used.
If your electrical outlets has no separate ground connection please use other ones that have
a earth ground connection. If you are not sure of the integrity of your home’s electrical system,
contact a licensed electrician for assistance.
3.
AC extension
cords are
not recommended
for use with this product. If an extension cord
must be used, be sure it is an approved type and has sufficient current carrying capacity
to power this product.
4.
Before cleaning the ASR Emitter, always turn Off the unit and unplug the power supply
cords.
5.
If you smell smoke, or an abnormal smell, immediately turn Off the ASR Emitter and
unplug the unit from the power supply and contact your ASR dealer.
6.
Don’t expose the Emitter to water or any liquid. Unplug immediately if the unit becomes
wet.
7.
Replace fuse only with the exact type originally included.
external power supplies
ASR Battery Power Supply
115 Volt: 16 Amps, Neozed slow-blow
1 Amps, slow-blow
230 Volt: 10 Amps, Neozed slow-blow
0,5 Amp, slow-blow
8.
THERE ARE NO SERVICEABLE PARTS INSIDE THE ASR EMITTER !
-
Do not attempt to repair or modify your ASR Emitter.
-
All service should be performed by qualified service personnel.
-
Do not open the units while it is attached to the AC outlet.
1.3
Placing the Emitter units
The
heat sinks
of the ASR Emitter
radiate
some heat, so please place the main unit in a place,
where
air
can
circulate
around the heat sinks. Never put another unit on top of the main unit.
The ASR power supplies do not radiate much heat. For best sonic performance please do not stack
the ASR power supplies units nor place the ASR power supply units too close to the main unit.
2.0
Connecting the ASR Emitter to your system
All
standard inputs
of the ASR Emitter are high level inputs with
identical technical
characteristics
, just the name is different. For connection of a turntables you may use the
ASR plug-in phono board or a separate phono preamplifier.
The source components should be placed close to the ASR Emitter’s main unit.
To obtain the best performance please use cables as short as possible.
If your source components are equipped with „fixed“ and „variable“ outputs always use
the „fixed“ outputs to connect the component to the ASR Emitter for better performance.
ATTENTION:
When you plug cables to the main unit please switch OFF the Emitter !
If you want to be absolutely save unplug the power cords to the AC outlet !
Tipp:
please use high quality interconnects, speaker cables and power cords to connect your ASR
Emitter. The performance of your system will be increased by using the best affordable cables.