ASR emitter, Manual, Page: 10 / 21

ASR Audio Systems Friedrich Schaefer, D-35745 Herborn, Germany +49 / 2772 – 42 905
High End Integrated Amplifier ASR Emitter I and II version 2009 on Page 10
On-/Off-Selector (= left knob)
Position Function
Off The unit is turned off, the power to the control circuits is disconneted.
Before you switch from „Standby“ to „Off“ please wait at least 20 seconds.
The ASR Emitter needs this time, to run all functions down.
Standby In this position
-
the ASR Emitter can be operated with the remote control
- you can record from source to tape
1 volume can be adjusted from 0 to 61dB, normal operating position,
energy saving mode is active.
2
volume can be adjusted from 0 to 76dB, energy saving mode is deactivated.
Emitters with additionally outputs :
Additional positions Function
A1 (speaker-)outputs „A“, normal operating position
B1
(speaker-)outputs „B“, normal operating position.
C the headset-output is active, the speaker-outputs are muted
A2 (speaker-)outputs „A“, volume control from 0 to 76dB,
B2
(speaker-)outputs „B“, volume control from 0 to 76dB
A+B1 (speaker-)outputs „A“ and „B“ selected to play together
If the ASR Emitter is controlled via remote control, the position of the left knob may not exactly
correspond with the actual operating mode. The chosen input is indicated by an Led above the
(right) input selector knob.
Volume control (= middle knob)
The volume of the ASR Emitter is controlled with a relays step control. The middle knob works
as an rotary pulse encoder and can be turned around 360°. The chosen volume will be displayed in
numbers from 0 to 76. In „Standby“-mode the volume can be pre selected up to 49 – this avoids
too high sound pressure levels when turning the ASR Emitter on.
Input selector (= right knob)
In the standard version of the ASR Emitter, the input selector has six positions: six high level
inputs and one tape input. To select an input, please move the input selector knob to the desired
input. The chosen input is indicated by a yellow Led.
Monitor-switch (= if supplied, right beside the input selector knob)
As an option, the ASR Emitter can be equipped with a tape monitor switch. When the ASR
Emitter is turned ON, pressing the tape monitor switch allows you to listen to the rear band signal.
When the monitor input is activate a green bar in the display is shining. When the ASR Emitter is
in the „Standby“-mode, pressing the tape-monitor switch activates the adjustments mode.(See 3.4)