ASR Audio Systems Friedrich Schaefer, D-35745 Herborn, Germany +49 / 2772 – 42 905
High End Integrated Amplifier ASR Emitter I and II version 2009 on Page 11
3.3
Operating the ASR Emitter via ASR remote control
All functions of the ASR Emitter can be controlled via the supplied ASR remote control.
To operate the ASR Emitter via ASR remote control, switch to „Standby“.
When you press a key on the ASR remote control, the display lights up and shows the selected
function. When using the ASR remote control, the three control knobs on the front panel of the
ASR Emitter are not moving. Leds around the knobs are showing the operation mode.
For remote control operation, the ASR Emitter uses the standard RC5 code set – this allows
the remote control operation with a wide variety of different programmable remote controls.
Philips and Marantz and many other brands uses the RC5 code, too.
Functions of the remote control buttons :
Button
Function
(right side)
Power
switches the ASR Emitter ON and OFF
Mute
lowers the volume for 15dB, pressing the button again back to the level before
Vol
upper “Vol”-button = increases the volume
lower “Vol”-button = decreases the volume
(left side)-
Mode
selects the adjust mode for balance, energy saving mode, display brightness etc.
and input level. press the “Mode”-button as long until the mode you want to adjust
is displayed; adjustments can now easily be made using the „Vol“ buttons
Inp
allows direct input selection: Ph, CD1, CD2, Tu, DT, Vi, Dir
upper “Inp”-button = switches the inputs clockwise,
lower “Inp”-button = switches the inputs counter-clockwise
3.4
Adjustments of the ASR Emitter
The ASR Emitter offers a lot of to adjustment possibilities.
With
remote :
The
adjustment menu
can be easily accessed by pressing the „
Tape
“-
button on the Roksan remote control.
At the
main unit
: Please switch the Emitter with the left knob to Standby.
Then push the „Tape Monitor“-button located right from the input selector.
When the ASR Emitter is not equipped with a Tape monitor the button is located at the right side
at the back of the display board inside the amp. For access you have to remove the top cover.
To adjust the parameter, please press either the “Vol”-buttons on the ASR remote control
or turn the middle knob on the ASR Emitter to the right (+) or left (-). To
save
your individual
adjustments please put the left knob of the ASR Emitter to the „
OFF
“-position and keep the unit
switched OFF for at least ten seconds. In this case all adjustments are stored.