ASR Audio Systems Friedrich Schaefer, D-35745 Herborn, Germany +49 / 2772 – 42 905
High End Integrated Amplifier ASR Emitter I and II version 2009 on Page 12
Adjusting the channel balance
Please
press
the “Mode”-button on the remote control (or the „Tape Monitor“ on the front plate)
once
– two yellow LEDs „Balance“ are flashing. Now you can either use the “Vol“-buttons
(upper “Vol”-button = balance to the left, lower “Vol”-button = balance to the right ) on the
ASR remote control or the middle knob of the ASR Emitter to adjust the channel balance.
If the balance is adjusted to
one side
, the corresponding yellow led „Balance“-LED is flashing.
When the balance is in the
middle
both yellow „Balance“-LEDs are flashing.
Adjusting the energy saving mode
The volume level, where the ASR Emitter switches automatically from energy saving mode
to
full power mode
can be adjusted in a wide range from 01 to 51.
If you set the display to „01“ the energy saving mode is disabled. The factory setting is „35“.
Please press the “Mode”-button on the remote control (or the „Tape Monitor“-button on the
front plate)
twice
– the green LED „Energy“ is flashing. Now either use the “Vol“-buttons
(upper “Vol”-button = ASR Emitter switches into normal operating mode at higher level,
lower “Vol”-button = ASR Emitter switches into normal operating mode at lower level) on the
ASR remote control or the middle knob of the ASR Emitter to adjust the energy saving mode.
Adjusting the display mode and brightness
The display of the ASR Emitter can be adjusted in brightness, parts of the display can be
illuminated all the time or not and so on. The actual setting is displayed numerical.
Factory setting is „07“: maximum brightness and the display is switched off 10 seconds after
the last turn of the knobs or receiving a signal from the remote control.
The display of the A
SR Emitter Blue Version
models is adjust to “37”. This means that the
number display and the blue Leds around the knobs that are showing the operation mode and
the chosen input are illuminated all the time with maximum brightness.
Please press the “Mode”-button on the ASR remote control (or the „Tape Monitor“-button on the
front plate)
three times
– the two yellow display numbers are flashing. Now either use the “Vol“-
buttons on the ASR remote control or the middle knob of the ASR Emitter to adjust the display.
left display number
Adjustment of the Leds switch ON Mode
0
display switches totally off after ten seconds
1
the Leds above the left and right knob are illuminated constantly
2
the two numbers of the display are illuminated constantly
3
equivalent to mode 1 and 2 together
4
mode Leds (Out, Balance etc.) are illuminated constantly
5
equivalent to mode 1 and 4 together
6
equivalent to mode 2 and 4 together
7
the whole display is illuminated constantly
right display number
Adjustment of brightness
0 to 7
0 (= off) to 7 (= max. brightness), altering the volume will
illuminate just the yellow numbers
8 to F
8 (= off) to F = (= max. brightness) altering the volume will
illuminate the whole display