LaserTraq
12
Wall Mounting Option
The Cradle/Charger is designed so that it can be used on a desktop, or
mounted on a wall. To mount it on the wall, you’ll need to “reverse” the
cradle, so that the cradle slopes out, not in.
To reverse the cradle, remove the six Philips head screws on the
underside of the cradle, then pull off the bottom section. Rotate the
bottom section of the case half a turn, then put it back on and re-fit the six
screws.
On the wall, you’ll need to attach two screws in a vertical line about
125mm apart, leaving the heads protruding a few millimetres. Place the
keyhole shaped holes on the cradle over the screw heads, and pull it
down to lock it in place. If the cradle is loose on the wall, remove it and
tighten the screws up a little.
Summary of Contents for LaserTraq
Page 2: ......
Page 5: ...LaserTraq 3...
